The central nervous system (CNS) and its resident immune cells, the microglia, develop from different embryonic germ layers. As a result, microglia do not intrinsically arise in most in vitro neural differentiation protocols, requiring the use of co-cultures to model neuroimmune interactions. This protocol describes a method for co-culturing human pluripotent stem cell (hPSC)-derived microglia and forebrain neurons by generating each cell type separately and then combining them under optimized culture conditions. This protocol aims for a final density of 5% microglia, which is the reported microglia density in the human cortex1,2,3.
The recommended co-culture period is 3 - 10 days. To ensure optimal microglia survival, do not exceed 10 days of culture following the 24-day microglia differentiation (e.g. steps 1 - 8 in section A under 'Directions for Use' in the STEMdiff™ Microglia PIS).
Cells may be cryopreserved at various points for increased flexibility in co-culture planning (please contact firstname.lastname@example.org for instructions).
*Required for microglia differentiation as outlined in the PIS’s for STEMdiff™ Hematopoietic Kit and for STEMdiff™ Microglia kits.
✝Required for forebrain-type neuron differentiation as outlined in the PIS for STEMdiff™ Forebrain Neuron kits.
Evaluate efficiency of microglia differentiation by flow cytometry. The resulting cell population should be > 80% positive for coexpression of CD45 and CD11b.
Optional: Microglia may be further cultured using STEMdiff™ Microglia Maturation Kit (Catalog #100-0020) prior to co-culture setup in Part III. However, do not exceed 10 days in total of additional culture time after microglia differentiation (total of maturation and co-culture period combined).
Note: When seeding neuronal precursors into STEMdiff™ Forebrain Neuron Maturation Medium (section C, step 1 under "Directions for Use" in the PIS), the suggested density for co-culture with microglia ranges from 1.5 x 104 - 4 x 104 cells/cm2. The optimal density should be determined by the user.
Continue the forebrain neuron maturation phase until neurons have been cultured in STEMdiff™ Forebrain Neuron Maturation Medium for at least 7 days.
Optional: If desired, the forebrain neuron maturation period may be extended prior to co-culture setup in Part III, by following the instructions in the PIS for STEMdiff™ Forebrain Neuron kits.
Verify successful forebrain neuron differentiation by performing immunocytochemistry on a subset of cultured cells. The resulting cell population should be > 90% positive for ꞵIII-tubulin and FOXG1, and < 10% positive for the astrocyte marker GFAP.
Part III: Prepare Optimized Microglia-Neuron Co-Culture Medium and Set Up Co-Culture
In the PIS for BrainPhys™, follow the instructions under ‘Preparation of Complete Differentiation Medium’ (section B) to prepare the required volume of BrainPhys™ Neuronal Medium + supplements.
Note: The required volume of medium will depend on the plate format and desired length of the co-culture period.
Thaw STEMdiff™ Microglia Supplement 2 (Component #100-0023 of STEMdiff™ Microglia Differentiation Kit) at room temperature (15 - 25°C) until just thawed, or alternatively at 2 - 8°C overnight. Mix thoroughly.
Note: If not used immediately, aliquot supplement and store at -20°C. Do not exceed the expiry date (EXP) as indicated on the label.
Note: If you do not have enough leftover STEMdiff™ Microglia Supplement 2 to prepare the optimized co-culture medium, please contact email@example.com to purchase this component individually.
Prepare optimized Microglia-Neuron Co-Culture Medium as follows:
a. Add STEMdiff™ Microglia Supplement 2 (250X) to the BrainPhys™ Neuronal Medium + supplements to a final concentration of 1X (e.g. 40 µL of supplement per 10 mL of medium).
b. Mix thoroughly.
Note: If not used immediately, store Microglia-Neuron Co-Culture Medium at 2 - 8°C for up to 2 weeks.
Collect microglia from Part I:
a. Transfer the entire cell suspension to a 15 mL conical tube. To ensure all cells are collected, additional washes may be performed using warm DMEM/F-12 with 15 mM HEPES.
b. Centrifuge at 300 x g for 5 minutes.
c. Remove supernatant and resuspend the pellet in an appropriate volume of Microglia-Neuron Co-Culture Medium.
d. Count cells using Trypan Blue and a hemocytometer.
Dilute the microglia cell suspension in additional Microglia-Neuron Co-Culture Medium to obtain the required final cell concentration and volume.
Microglia Seeding Density Considerations
The concentration and volume of the final microglia suspension should be optimized by the user and will depend on the desired microglia-to-forebrain neuron ratio, the number of culture wells used, the plate format, and the initial cell density of forebrain neuronal precursors plated in Part II.
The recommended seeding density for microglia in co-culture is half of the forebrain neuron precursor density seeded in Part II, Step 1 (e.g. a 1:2 microglia-to-neuronal precursor ratio). This will result in microglia comprising approximately 5% of the final co-culture cell population after 7 days.
Note: The decrease in proportion of microglia in the final co-culture is attributable to forebrain neuronal precursors proliferating to a small degree during early maturation, failure of all seeded microglia to adhere, unavoidable loss of semi-adherent microglia during subsequent medium changes, and a small proportion of microglia undergoing cell death.
If relatively high forebrain neuronal precursor proliferation is observed during early forebrain neuron maturation, the microglia seeding density may be increased to achieve the desired proportion of microglia in the final co-culture after 7 days.
The relative percentage of microglia-to-neurons differs between brain regions1,2,3, and the seeding densities of both cell types may be adjusted accordingly as desired.
Remove and discard the culture medium from the forebrain neurons generated in Part II.
Seed the microglia suspension prepared in Part III, Step 6 onto the forebrain neurons.
Place the plate in a 37°C and 5% CO2 incubator. Distribute cells evenly by moving the plate in several quick, short, back-and-forth and side-to-side motions.
Maintain the co-cultures for 3 - 10 days by performing a half-medium change every 2 - 3 days using Microglia-Neuron Co-Culture Medium prepared in Part III, step 3.
Note: Microglia are semi-adherent and may unintentionally be removed during medium changes. Prior to performing half-medium changes, centrifuge the plate in a swinging-bucket centrifuge with plate adaptors at 100 x g for 2 minutes to force the cells to settle.
Characterize by Immunocytochemistry
Immunocytochemistry may be performed after 3-10 days of co-culture, using the following primary antibodies:
Total cell density may be assessed by DAPI staining.
Expected observations: Cultures should consist of healthy microglia integrated among forebrain neurons, with < 10% astrocytes present. Microglia should display an unactivated, ramified morphology with extended cellular processes.
Human pluripotent stem cell models can be powerful tools for disease phenotype validation, screening, and insights into human development. Explore our complete portfolio of products to support your hPSC to neural culture workflow.
Scientific Resources for Neurological Disease Modeling
View webinars from leading researchers and browse scientific posters for examples of how to generate patient-specific neuronal cell types from induced pluripotent stem cells (iPSCs), bridging the gap between studies using animal models and clinical research.
StemCell Technologies Inc. and affiliates ("STEMCELL Technologies") does not
share your email address with third parties. StemCell Technologies Inc. will use your email address to
confirm your identity and send you newsletters, transaction-related emails, promotional and customer
your email preferences at any time.