How to Isolate Human Colonic Crypts from Intestinal Biopsies
Materials
- D-PBS without Ca++ and Mg++ (e.g. Catalog #37350)
- DMEM/F-12 with 15 mM HEPES (e.g. Catalog #36254)
- Bovine serum albumin (BSA)
- 50 mL conical tube (e.g. Falcon® Conical Tubes, Catalog #38010)
- 24-well plate (e.g. Costar® 24-Well Plate, Catalog #38017 or Falcon® 24-Well Plate, Catalog #38021)
- 15 mL conical tubes (e.g. Falcon® Conical Tubes, Catalog #38009)
- Microcentrifuge tubes (e.g. Costar® Microcentrifuge Tubes, Catalog #38089)
Protocol
- Place the following reagents on ice: D-PBS (without Ca++ and Mg++) and DMEM + 1% BSA.
Preparation of DMEM + 1% BSA
Use sterile technique to prepare DMEM + 1% BSA. The following example is for preparing 50 mL of DMEM + 1% BSA. If preparing other volumes, adjust accordingly.
- Add 2 mL of 25% BSA to 48 mL of DMEM/F-12 with 15 mM HEPES in a 50 mL conical tube.
- Mix well by inversion. Place on ice.
NOTE: If not used immediately, store at 2 - 8°C for up to 6 months.
- Warm a tissue culture-treated 24-well plate in a 37°C incubator for at least 2 hours.
- In a 15 mL conical tube, wash the tissue sample obtained from colon biopsies with 10 mL of ice-cold PBS. Allow the tissue to settle by gravity (~5 seconds), then aspirate the supernatant.
- Repeat step 3, leaving 1 mL of supernatant in the tube.
- Using a 1 mL pipettor, transfer the tissue and remaining supernatant to a 1.5 mL microcentrifuge tube.
- Using sterile scissors, thoroughly mince the tissue into the smallest pieces possible. Transfer the tissue fragments to a new 15 mL conical tube using a 1 mL pipettor. Rinse the microcentrifuge tube with D-PBS and add the rinse to the tissue fragments.
- Allow the tissue fragments to settle by gravity (~5 seconds), then aspirate supernatant.
- Add 10 mL of Gentle Cell Dissociation Reagent, then incubate on ice on a rocking platform set at medium speed (~40 rpm) for 30 minutes.
- Centrifuge at 290 x g for 5 minutes. Aspirate supernatant.
Note: For the remainder of the protocol, pre-wet pipette tips with DMEM + 1% BSA before manipulating the tissue sample. This prevents crypts from sticking to the wall of the pipette tip.
- Add 1 mL of ice-cold DMEM + 1% BSA. Vigorously pipette up and down 20 times with a 1 mL pipettor to remove crypts from tissue.
Note: Avoid touching the side/bottom of the tube with the pipette tip.
- Using a 1 mL pipettor, pass the contents of the tube through a 70 µm strainer (tilted on its side) into a new 15 mL conical tube. Rinse the original tube with 1 mL of DMEM + 1% BSA and pass through the strainer into the tube. This final tube contains isolated crypts that can be used for establishing intestinal organoid culture using IntestiCult™ Organoid Growth Medium (Human).
Request Pricing
Thank you for your interest in this product. Please provide us with your contact information and your local representative will contact you with a customized quote. Where appropriate, they can also assist you with a(n):
Estimated delivery time for your area
Product sample or exclusive offer
In-lab demonstration