Euthanize mice as per your institutional guidelines.
Pin the mouse down by each foot to a dissection board.
Spray down the abdomen with 70% ethanol or isopropyl alcohol.
Use forceps to pull the skin up above the sternum and make an incision along the midline with sterile blunt-end scissors. Be careful not to pierce the peritoneum.
Pull the skin away to fully expose the peritoneum.
Attach a 25 gauge needle to a 6 mL syringe and fill the syringe with 5 mL of cold EasySep™ Buffer (or Ca+2 and Mg+2 free PBS with 2% FBS and 1 mM EDTA).
With the beveled side facing away from the mouse, insert the needle through the peritoneal wall at the lower quadrant of the abdomen at a ~10 degree angle and almost parallel with the vertebral column. Avoid puncturing internal organs.
Inject 5 mL of EasySep™ Buffer.
Unpin the mouse and shake and invert the mouse several times to mix the buffer throughout the peritoneal cavity. Alternatively, massage the inflated peritoneal cavity for at least 30 seconds.
Attach a smaller gauge needle to a new syringe.
If applicable, pin the mouse down again. With the beveled side facing away from the mouse, insert the needle into the inflated peritoneal cavity at the lower quadrant of the abdomen and move the needle away from intestines and fat deposits to prevent the needle from being blocked. Slowly aspirate the peritoneal fluid.
Remove needle from syringe and dispense the peritoneal fluid into a 50 mL Falcon® Conical Tube (Catalog #100-0090) or a 15 mL Falcon® Conical Tube (Catalog #100-0092) when processing a smaller number of mice.
Centrifuge at 300 x g for 10 minutes at room temperature with the brake set on low (i.e. deceleration set at 1 - 2).
Carefully remove and discard the supernatant without disturbing the cell pellet.
Resuspend cells in recommended medium* at the required cell concentration for your downstream procedure.
*EasySep™ Buffer (or Ca+2- and Mg+2-free PBS with 2% FBS and 1 mM EDTA) if further isolation with an EasySep™ kit will be performed.
Related Resources and Products
EasySep™ Mouse F4/80 Positive Selection Kit
Use EasySep™ to isolate F4/80+ macrophages in as little as 24 minutes—without the use of columns—from mouse splenocytes, lung tissue, and peritoneal lavage.
StemCell Technologies Inc. and affiliates ("STEMCELL Technologies") does not
share your email address with third parties. StemCell Technologies Inc. will use your email address to
confirm your identity and send you newsletters, transaction-related emails, promotional and customer
your email preferences at any time.